P1308 HYUNDAI - Acceleration Sensor Circuit Low Input
P1308 HYUNDAI Possible Causes
- Faulty Acceleration Sensor
- Acceleration Sensor harness is open or shorted
- Acceleration Sensor circuit poor electrical conection
How is the P1308 HYUNDAI code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1308 HYUNDAI code
Labor: 1.0The cost to diagnose the P1308 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?If the value exceeds threshold value, the Engine Control Module (ECM) judged this as a fault and the P1308 is set.
- Engine Light ON (or Service Engine Soon Warning Light)
P1308 HYUNDAI MeaningThe Chassis acceleration(Rough Road) sensor consists of a piezoelectric vibration pick up which detects vertical acceleration of the vehicle.The sensor signal is used by the Engine Control Module (ECM) to determine the degree of vertical movement of the car, for example, on a bumpy road.Since this may also cause uneven engine running, the ECM uses the signal to distinguish the phenomenon from actual misfiring.
More InformationNeed more information on how to fix the P1308 HYUNDAI code?
Get Access to Factory Service Manuals