P1277 Buick Code - Accelerator Pedal Position Sensor 1 Circuit Low Voltage
Quick Answer
The P1277 Buick code indicates a problem with the Accelerator Pedal Position Sensor 1 Circuit, specifically a low voltage condition. Common causes include Malfunctioning accelerator pedal position sensor, Damaged or corroded wiring connections, Faulty ECM. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P1277 Buick indicates Accelerator Pedal Position Sensor 1 Circuit Low Voltage.
- Common causes
- Common causes include Malfunctioning accelerator pedal position sensor, Damaged or corroded wiring connections, Faulty ECM.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P1277 Buick Description
The P1277 Buick code indicates a problem with the Accelerator Pedal Position Sensor 1 Circuit, specifically a low voltage condition. The accelerator pedal position sensor is a crucial component of the vehicle's electronic throttle control system. It is responsible for sending signals to the engine control module (ECM) to determine the amount of throttle opening based on the driver's input. A low voltage reading from this sensor can lead to various performance issues and potentially cause the vehicle to run poorly or even stall.
Common Causes of P1277 Buick
- Malfunctioning accelerator pedal position sensor
- Damaged or corroded wiring connections
- Faulty ECM
- Electrical issues such as short circuits or open circuits
- Environmental factors such as moisture intrusion
Symptoms of P1277 Buick
- Reduced engine power
- Engine stalling or hesitation
- Poor acceleration
- Check Engine Light illuminated
- Decreased fuel efficiency
How to Fix P1277 Buick
- Use a diagnostic scan tool to verify the P1277 code and identify the specific cause of the low voltage condition.
- Inspect the wiring harness and connectors for any damage or corrosion. Repair or replace as necessary.
- Test the accelerator pedal position sensor using a multimeter to ensure it is functioning correctly. Replace if faulty.
- Clear the fault codes from the ECM memory and perform a test drive to confirm the issue has been resolved.
- If the problem persists, further diagnosis may be required to pinpoint the exact cause, such as checking the ECM functionality or conducting additional electrical tests.
Cost to Fix P1277 Buick
The typical repair costs for addressing a P1277 Buick code can vary depending on the specific cause of the issue. In general, the cost of replacing a faulty accelerator pedal position sensor can range from $100 to $300, including parts and labor. Additional costs may apply if wiring repairs or ECM replacement are necessary. It's important to note that diagnostic time and labor rates at auto repair shops can vary, so it's recommended to obtain multiple quotes for a more accurate estimate.
When is the Code Detected?
Need more information about the P1277 Buick code?
Need more information on how to fix the P1277 Buick code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P1277 Buick code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P1277 Buick Code
No Frequently Asked Questions about P1277 Buick Code found.
Discuss the causes and fixes for P1277 Buick OBDII Code
Code P1277 Buick comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.