P1276 GMC Possible Causes
- Faulty Accelerator Pedal Position (APP)
- Accelerator Pedal Position harness is open or shorted
- Accelerator Pedal Position circuit poor electrical connection
How do I fix code P1276 GMC
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P1276 GMC code
Labor: 1.0The cost of diagnosing the P1276 GMC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P1276 GMC code detected?The Engine Control Module (ECM) detected a voltage below 0.2 volts or above 4.25 volts on the APP signal
P1276 GMC Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1276 GMC MeaningThe Accelerator Pedal Position (APP) sensors are located within the Throttle Actuator Control (TAC) module assembly. The TAC module assembly is mounted to the accelerator pedal bracket. There are 3 individual APP sensors within the TAC module. Three separate signal circuits, low reference circuits, and 5-volt reference circuits are used in order to determine the accelerator pedal position. The APP sensor signal voltages increase when the accelerator pedal is depressed.
P1276 GMC More InformationNeed more information on how to fix the P1276 GMC code?
Get Access to Factory Service Manuals