P1274 INFINITI - Air Fuel Ratio Sensor 1 Bank 1 Rich Shift Monitoring
P1274 INFINITI Possible Causes
- Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
- Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
- Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
- Fuel pressure
- Faulty Fuel injector
- Faulty Air Flow Meter
How do I fix code P1274 INFINITI
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
P1274 INFINITI Tech NotesIf one or more sensors are replaced the Engine Control Module (ECM) Mixture Ratio Self-Learning clearing procedure must be perform.
There is a factory service bulletin for the following Infiniti models:
2003-2006 G35 Sedan
2003-2007 G35 Coupe
2006-2012 G37 Sedan
2008-2012 G37 Coupe
Infiniti Factory Service Bulletin OBDII Code P1274
Cost of diagnosing the P1274 INFINITI code
Labor: 1.0The cost of diagnosing the P1274 INFINITI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P1274 INFINITI code detected?The A/F signal computed by ECM from the A/F sensor 1 signal is shifted to the rich side for a specified period.
P1274 INFINITI Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible rough engine idle
P1274 INFINITI MeaningThe Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide λ range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance.
An electronic circuit controls the pump current through the oxygen-pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800 C (1,292 - 1,472 F).
P1274 INFINITI More InformationNeed more information on how to fix the P1274 INFINITI code?
Get Access to Factory Service Manuals