Engine-Codes - Ford - P1260 2008 Ford Fusion

P1260 2008 Ford Fusion Code - Theft Detected - Vehicle Immobilized

- Code Popularity: 7,158 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1260 2008 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Incorrectly programmed Powertrain Control Module (PCM)
  • Incorrectly programmed Instrument Cluster (IC) or Instrument Panel Cluster (IPC)
  • Previous theft condition
  • Anti-theft system concern
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1260 2008 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1260 2008 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1260 2008 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The Engine Control Module (ECM) has received a signal from the Anti-Theft system that a violation has occurred

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Start/Stall or Crank/No Start

What Does the P1260 2008 Ford Fusion Code Mean?

The P1260 code can be set if the Passive Anti-Theft System (PATS) has determined a theft condition existed and the engine is disabled or an engine start was attempted using a non-PATS key. This Diagnostic Trouble Code (DTC) is a good indicator to check the PATS for DTCs. This DTC can also be set when a new Instrument Cluster (IC), Instrument Panel Cluster (IPC) or Powertrain Control Module (PCM) is installed without correctly programming either module even if the vehicle is not equipped with PATS.

P1260 2008 Ford Fusion Code - Theft Detected - Vehicle Immobilized

Need more Information on the Code?

Need more information on how to fix the P1260 2008 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1260 2008 Ford Fusion code diagnosed by a professional: Find a repair shop in your area