P1237 2008 FORD FUSION - Fuel Pump Secondary Circuit Fault
P1237 2008 FORD FUSION Possible Causes
- Faulty Fuel Pump Driver Module (FPDM)
- Fuel Pump Driver Module (FPDM) harness is open or shorted
- Fuel Pump Driver Module (FPDM) circuit poor electrical connection
- Faulty fuel pump
How do I fix code P1237 2008 FORD FUSION?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P1237 2008 FORD FUSION code
Labor: 1.0The cost of diagnosing the P1237 2008 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?Fuel pump driver module has detected a fault in the fuel pump secondary circuit
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine will not start
P1237 2008 FORD FUSION MeaningFuel Pump Driver Modules (FPDM) controls the voltage to the Fuel Pump in order to maintain proper fuel pressure over the full operating range of the engine. The P1237 code indicates the FPDM detected a fuel pump secondary circuit concern. The FPDM sends a message to the Powertrain Control Module (PCM) through the Fuel Pump Monitor (FPM) circuit indicating this concern was detected. The PCM sets the DTC when the message is received.
P1237 2008 FORD FUSION More InformationNeed more information on how to fix the P1237 2008 FORD FUSION code?
Get Access to Factory Service Manuals