Engine-Codes - Nissan - P1226 2010 NISSAN ROGUE

P1226 2010 NISSAN ROGUE - Closed Throttle Position Learning Performance Problem

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

P1226 2010 NISSAN ROGUE Possible Causes

  • Faulty Electric throttle control actuator (TP sensor 2)
  • Electric throttle control actuator (TP sensor 2) harness is open or shorted
  • Electric throttle control actuator (TP sensor 2) circuit poor electrical connection

How is the P1226 2010 NISSAN ROGUE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

Start by cleaning the throttle and adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.

Nissan Rogue Idle Air Volume Relearn

What is the cost to diagnose the P1226 2010 NISSAN ROGUE code

Labor: 1.0

The cost to diagnose the P1226 2010 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

Closed throttle position learning is not performed successfully, repeatedly.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1226 2010 NISSAN ROGUE Meaning

Electric Throttle Control Actuator consists of throttle control motor, throttle position sensor, etc. The Throttle Position (TP) sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the Engine Control Module (ECM). In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.

More Information

Need more information on how to fix the P1226 2010 NISSAN ROGUE code?
Get Access to Factory Service Manuals

Need more help?

Get the P1226 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area