P1225 2011 NISSAN ROGUE - Closed Throttle Position Learning Performance Problem
P1225 2011 Nissan Rogue Possible Causes
- Faulty Electric throttle control actuator (TP sensor 2)
- Electric throttle control actuator (TP sensor 2) harness is open or shorted
- Electric throttle control actuator (TP sensor 2) circuit poor electrical connection
P1225 2011 Nissan Rogue Tech NotesStart by cleaning the throttle and adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.
Nissan Rogue Idle Air Volume Relearn
Cost of diagnosing the P1225 2011 Nissan Rogue code
Labor: 1.0The cost of diagnosing the P1225 2011 Nissan Rogue code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?Closed throttle position learning value is excessively low.
P1225 2011 Nissan Rogue Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1225 2011 Nissan Rogue MeaningElectric Throttle Control Actuator consists of throttle control motor, throttle position sensor, etc. The Throttle Position (TP) sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the Engine Control Module (ECM). In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.