P1172 2009 HONDA ACCORD Code - Rear A/F Sensor Bank 1 Sensor 1 Circuit Out Of Range High
|P1172 2009 HONDA ACCORD code possible causes
- Faulty Air/Fuel Ratio Bank 1 Sensor 1
- Air/Fuel Ratio Bank 1 Sensor 1 harness is open or shorted
- Air/Fuel Ratio Bank 1 Sensor 1 circuit poor electrical connection
|How is the P1172 2009 HONDA ACCORD code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|What is the cost to diagnose the P1172 2009 HONDA ACCORD code
Labor: 1.0The cost to diagnose the P1172 2009 HONDA ACCORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are P1172 2009 HONDA ACCORD code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is P1172 2009 HONDA ACCORD code meaning?The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM). A heater for the sensor element is embedded in the A/F sensor (sensor 1). It is activated and heats the sensor to stabilize and speed the detection of oxygen content by controlling current flowing through the heater. An increase in the current levels off as the applied voltage to the element electrode reaches a certain range because the amount of oxygen which is led through the diffusion layer is limited. The current amperage is proportional to oxygen content in the exhaust gas, so the air/fuel ratio is detected by the measurement of the current amperage. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
If the A/F sensor (sensor 1) voltage is low, the air/fuel ratio is lean, and the ECM uses A/F feedback control to issue a Rich command. If the A/F sensor (sensor 1) voltage is high, the air/fuel ratio is rich, and the ECM uses A/F feedback control to issue a Lean command.
|Need more information with the P1172 2009 HONDA ACCORD code?Need more information on how to fix the P1172 2009 HONDA ACCORD code?
Get Access to Factory Service Manuals