Engine-Codes - Honda - P1157 2009 HONDA ACCORD

P1157 2009 HONDA ACCORD - Air/Fuel Ratio Sensor 1 Range/Performance Problem

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What is this?

P1157 2009 HONDA ACCORD Possible Causes

  • Faulty Air/Fuel Ratio Sensor 1
  • Air/Fuel Ratio Sensor 1 harness is open or shorted
  • Air/Fuel Ratio Sensor 1 circuit poor electrical connection

How do I fix code P1157 2009 HONDA ACCORD

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the P1157 2009 HONDA ACCORD code

Labor: 1.0

The cost of diagnosing the P1157 2009 HONDA ACCORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

If the element is not activated or the Engine Control Module (ECM) terminal voltage is a set value or less for at least a set time period when the power is drawn to the A/F sensor (sensor 1) heater, a malfunction is detected and the code is stored.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1157 2009 HONDA ACCORD Meaning

The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM). A heater for the sensor element is embedded in the A/F sensor (sensor 1). It is activated and heats the sensor to stabilize and speed the detection of oxygen content by controlling current flowing through the heater. An increase in the current levels off as the applied voltage to the element electrode reaches a certain range because the amount of oxygen which is led through the diffusion layer is limited. The current amperage is proportional to oxygen content in the exhaust gas, so the air/fuel ratio is detected by the measurement of the current amperage. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
If the A/F sensor (sensor 1) voltage is low, the air/fuel ratio is lean, and the ECM uses A/F feedback control to issue a Rich command. If the A/F sensor (sensor 1) voltage is high, the air/fuel ratio is rich, and the ECM uses A/F feedback control to issue a Lean command.

P1157 2009 HONDA ACCORD More Information

Need more information on how to fix the P1157 2009 HONDA ACCORD code?
Get Access to Factory Service Manuals

Need more help?

Get the P1157 2009 Honda Accord code diagnosed by a professional: Find a repair shop in your area