P1153 BUICK - HO2S Insufficient Switching Bank 2 Sensor 1
P1153 BUICK Possible Causes
- Faulty Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1
- Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1 harness is open or shorted
- Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1 circuit poor electrical connection
How is the P1153 BUICK code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1153 BUICK code
Labor: 1.0The cost to diagnose the P1153 BUICK code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?A DTC P1153 sets when the Powertrain Control Module (PCM) determines that the HO2S did not switch enough times.
- Engine Light ON (or Service Engine Soon Warning Light)
P1153 BUICK MeaningThe Powertrain Control Module (PCM) monitors the Heated Oxygen Sensor (HO2S) activity for 100 seconds. During this monitor period the PCM counts the number of times that the HO2S switches from rich to lean and lean to rich.
A lean to rich switch is determined when the HO2S voltage changes from less than 300 mV to greater than 600 mV. A rich to lean switch is determined when the HO2S voltage changes from more than 600 mV to less than 300 mV.
More InformationNeed more information on how to fix the P1153 BUICK code?
Get Access to Factory Service Manuals