Engine-Codes - Audi - P1136 AUDI

P1136 AUDI - Long Term Fuel Trim Add. Fuel B1 System Too Lean

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

P1136 AUDI Possible Causes

  • Intake air leak
  • Faulty O2 Sensor
  • Faulty Mass Air Flow (MAF) Sensor
  • O2 Sensor harness is open or shorted
  • O2 Sensor circuit poor electrical connection

How is the P1136 AUDI code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

2002 Volkswagen Passat





User Submitted Video

What is the cost to diagnose the P1136 AUDI code

Labor: 1.0

The cost to diagnose the P1136 AUDI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1136 AUDI Meaning

This fault code is stored in the Engine Control Module (ECM) when the ECM is no longer capable of controlling the air-fuel ratio. For the correct operation of the catalytic converter, the ECM is required to keep the Air-Fuel Ratio (AFR) at approximately lambda 1; this equates to an AFR of 14.7:1 by mass. This is achieved by trimming the fuel mixture to the required amount to cater for slight anomalies during normal operating conditions. However, when a fault causes the fuel trim to exceed a predetermined level the malfunction indicator light is illuminated and a limited operating strategy is employed. The pre-catalyst exhaust gas oxygen sensor is the primary component used for calculating the fuel trim once the system enters closed-loop control. The fuel trim data can be displayed as a percentage, either positive or negative.
This Diagnostic Trouble Code (DTC) can be caused by a faulty mass airflow sensor, fuel pressure regulator, fuel pump, exhaust or intake leaks, secondary air injection leaks, or vacuum leaks. Additionally, any mechanical faults can cause this DTC as well. Common failure points associated with this code are a damaged EVAP purge regulator valve, brake booster, and hoses, electric vacuum pump (if equipped), PVC or ventilation system.

More Information

Need more information on how to fix the P1136 AUDI code?
Get Access to Factory Service Manuals

Need more help?

Get the P1136 Audi code diagnosed by a professional: Find a repair shop in your area