P1132 2002 NISSAN SENTRA - Swirl Control Valve Circuit
P1132 2002 NISSAN SENTRA Possible Causes
- Faulty Swirl Control Valve
- Swirl Control Valve harness is open or shorted
- Swirl Control Valve circuit poor electrical connection
How is the P1132 2002 NISSAN SENTRA code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1132 2002 NISSAN SENTRA code
Labor: 1.0The cost to diagnose the P1132 2002 NISSAN SENTRA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?An improper voltage signal is sent to Engine Control Module (ECM).
- Engine Light ON (or Service Engine Soon Warning Light)
P1132 2002 NISSAN SENTRA MeaningSwirl control valve consists of actuator and valve. The valve is installed in the intake manifold, and the actuator is connected to the rear end of the valve shaft.
The swirl control valve uses a step motor which has four winding phases. It operates according to the output pulse signal of the Engine Control Module (ECM). Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes. When no change in the control position is needed, the ECM does not issue the pulse signal. A certain voltage signal is issued so that the valve remains at that particular opening.
More InformationNeed more information on how to fix the P1132 2002 NISSAN SENTRA code?
Get Access to Factory Service Manuals