Engine-Codes - Ford - P1124 2009 FORD FUSION

P1124 2009 FORD FUSION - Throttle Position Sensor Out of Self-Test Range

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

P1124 2009 FORD FUSION Possible Causes

  • Binding or bent throttle linkage
  • Faulty Throttle Position Sensor
  • Throttle Position Sensor harness is open or shorted
  • Throttle Position Sensor circuit poor electrical connection

How is the P1124 2009 FORD FUSION code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

The throttle position (TP) sensor circuit is monitored by the powertrain control module (PCM) for an out of range TP rotation angle or voltage input. The test fails if the TP rotation angle or voltage reading is less than 13.27% (0.66 volt) or greater than 23.52% (1.17 volts).

What is the cost to diagnose the P1124 2009 FORD FUSION code

Labor: 1.0

The cost to diagnose the P1124 2009 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

Engine Control Module (ECM) detected a Thottle Position (TP) sensor return voltage above or below expected value at an idle condition

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1124 2009 FORD FUSION Meaning

The Throttle Position Sensor (TPS) responds to the accelerator pedal movement. The TPS is a rotary potentiometer sensor that provides a signal to the Powertrain Control Module (PCM) that is linearly proportional to the throttle plate/shaft position. As the TPS is rotated by the throttle shaft, the following operating conditions are determined by the PCM:
• Closed throttle (includes idle or deceleration)
• Part throttle (includes cruise or moderate acceleration)
• Wide open throttle (includes maximum acceleration or de-choke on crank)
• Throttle angle rate

More Information

Need more information on how to fix the P1124 2009 FORD FUSION code?
Get Access to Factory Service Manuals

Need more help?

Get the P1124 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area