P1122 PONTIAC - Throttle Position Sensor Circuit Intermittent Low Voltage
P1122 PONTIAC Possible Causes
- Faulty Throttle Position Sensor
- Throttle Position Sensor harness is open or shorted
- Throttle Position Sensor circuit poor electrical connection
- Throttle Position Sensor not properly adjusted
How is the P1122 PONTIAC code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1122 PONTIAC code
Labor: 1.0The cost to diagnose the P1122 PONTIAC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?When the Powertrain Control Module (PCM) senses a signal voltage lower than the normal operating range of the sensor, the P1121 will set.
- Engine Light ON (or Service Engine Soon Warning Light)
P1122 PONTIAC MeaningThe Throttle Position (TP) sensor is a potentiometer. The TP sensor provides a voltage signal that changes relative to throttle blade angle. This signal voltage is one of the most important inputs used by the Powertrain Control Module (PCM). The TP sensor has a 5.0 volt reference, a ground and a signal circuit.
TP sensor Signal voltage should be about 0.6 volt at idle. The TP sensor voltage should increase to above 4.0 volts at wide open throttle (WOT).
More InformationNeed more information on how to fix the P1122 PONTIAC code?
Get Access to Factory Service Manuals