Engine-Codes - Ford - P1114 2006 Ford Fusion

P1114 2006 Ford Fusion Code - Intake Air Temperature Sensor 2 Circuit Low

- Code Popularity: 1,996 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P1114 2006 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Air Temperature Sensor 2
  • Intake Air Temperature Sensor 2 harness is open or shorted
  • Intake Air Temperature Sensor 2 circuit poor electrical connection
  • Damaged Powertrain Control Module (PCM)

Code Tech Notes

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor. Monitor the IAT on a scan tool. Look for sudden changes in the reading when the harness is wiggled or the sensor is tapped.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1114 2006 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P1114 2006 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P1114 2006 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P1114 2006 Ford Fusion Code Mean?

The IAT sensor is a thermistor device in which resistance changes with temperature. The electrical resistance of a thermistor decreases as the temperature increases, and the resistance increases as the temperature decreases. The varying resistance affects the voltage drop across the sensor terminals and provides electrical signals to the Powertrain Control Module (PCM) corresponding to temperature.
Thermistor-type sensors are considered passive sensors. A passive sensor is connected to a voltage divider network so that varying the resistance of the passive sensor causes a variation in total current flow. Voltage that is dropped across a fixed resistor in a series with the sensor resistor determines the voltage signal at the PCM. This voltage signal is equal to the reference voltage minus the voltage drop across the fixed resistor.
The IAT sensor provides air temperature information to the PCM. The PCM uses the air temperature information as a correction factor in the calculation of fuel, spark, and air flow.
The IAT sensor provides a quicker temperature change response time than the ECT or CHT sensor.
Currently there are 2 types of IAT sensors used, a stand alone, non-integrated type and an integrated type. Both types function the same, however the integrated type is incorporated into the mass air flow (MAF) sensor instead of being a stand-alone sensor.
P1114 2006 Ford Fusion Code - Intake Air Temperature Sensor 2 Circuit Low

Need more Information on the Code?

Need more information on how to fix the P1114 2006 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1114 2006 Ford Fusion code diagnosed by a professional: Find a repair shop in your area