Engine-Codes -
Ford -
P1102 FORD
P1102 FORD - Mass Air Flow Sensor In Range But Lower Than Expected
Table of contents
P1102 FORD Possible Causes
- Faulty Mass Air Flow Sensor
- Air leak before or after sensor
- Mass Air Flow Sensor harness is open or shorted
- Mass Air Flow Sensor circuit poor electrical connection
How is the P1102 FORD code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.What is the cost to diagnose the P1102 FORD code
Labor: 1.0
The cost to diagnose the P1102 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.When is the code detected?
The Engine Control Module (ECM) detected a Mass Air Flow (MAF) sensor signal below calibrated limitPossible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P1102 FORD Meaning
The Mass Air Flow (MAF sensor circuit is monitored by the Powertrain Control Module (PCM) for an out of range air flow (or voltage) input. If during key ON engine OFF the air flow voltage signal is greater than 0.27 volts the test fails. Likewise, if during key ON engine running, an air flow voltage signal is not within 0.46 volt to 2.44 volts, the test fails.More Information
Need more information on how to fix the P1102 FORD code?Get Access to Factory Service Manuals