P1101 2012 FORD FUSION - Mass Air Flow Sensor Out of Self-Test Range
P1101 2012 FORD FUSION Possible Causes
- Faulty Mass Air Flow Sensor
- Air leak before or after sensor
- Mass Air Flow Sensor harness is open or shorted
- Mass Air Flow Sensor circuit poor electrical connection
How is the P1101 2012 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1101 2012 FORD FUSION code
Labor: 1.0The cost to diagnose the P1101 2012 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?The Engine Control Module (ECM) detected a Mass Air Flow (MAF) sensor signal above or below calibrated limit
- Engine Light ON (or Service Engine Soon Warning Light)
P1101 2012 FORD FUSION MeaningThe Mass Air Flow (MAF sensor circuit is monitored by the Powertrain Control Module (PCM) for an out of range air flow (or voltage) input. If during key ON engine OFF the air flow voltage signal is greater than 0.27 volts the test fails. Likewise, if during key ON engine running, an air flow voltage signal is not within 0.46 volt to 2.44 volts, the test fails.
More InformationNeed more information on how to fix the P1101 2012 FORD FUSION code?
Get Access to Factory Service Manuals