Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
The cost to diagnose the P1101 2011 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Engine Control Module (ECM) detected a Mass Air Flow (MAF) sensor signal above or below calibrated limit
The Mass Air Flow (MAF sensor circuit is monitored by the Powertrain Control Module (PCM) for an out of range air flow (or voltage) input. If during key ON engine OFF the air flow voltage signal is greater than 0.27 volts the test fails. Likewise, if during key ON engine running, an air flow voltage signal is not within 0.46 volt to 2.44 volts, the test fails.
Need more information on how to fix the P1101 2011 FORD FUSION code?
Get Access to Factory Service Manuals
Get the P1101 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area