P1100 2008 FORD FUSION - Mass Air Flow Sensor Intermittent
P1100 2008 FORD FUSION Possible Causes
- Faulty Mass Air Flow Sensor
- Air leak before or after sensor
- Mass Air Flow Sensor harness is open or shorted
- Mass Air Flow Sensor circuit poor electrical connection
How is the P1100 2008 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P1100 2008 FORD FUSION code
Labor: 1.0The cost to diagnose the P1100 2008 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?The Engine Control Module (ECM) detected a Mass Air Flow (MAF) sensor signal above or below calibrated limit
- Engine Light ON (or Service Engine Soon Warning Light)
P1100 2008 FORD FUSION MeaningThe Mass Air Flow (MAF) Sensor circuit is monitored by the Powertrain Control Module (PCM) for sudden voltage (or air flow) input change through the Comprehensive Component Monitor (CCM). If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory Diagnostic Trouble Code (DTC) P1100 is stored.
More InformationNeed more information on how to fix the P1100 2008 FORD FUSION code?
Get Access to Factory Service Manuals