Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
There is a Factory Service Bulletin for the following GMC models:
2016-2018 GMC Sierra 1500
2019 GMC Sierra Limited
Dead Battery / P1682 P129D P10E4 P2535 / Crank No Start
The cost to diagnose the P10E4 GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Engine Control Module (ECM) contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. Relays are used to control a high-power circuit with a low power signal. The output circuit is switched to the ground to activate the component. The Diagnostic Trouble Code (DTC) will be set when the Control Circuit is out of range for greater than 1 s.
Need more information on how to fix the P10E4 GMC code? Get Access to Factory Service Manuals
Get the P10E4 GMC code diagnosed by a professional: Find a repair shop in your area