Engine-Codes - Infiniti - P1089 INFINITI

P1089 INFINITI Code - VVEL Control Shaft Position Sensor Bank 1 Circuit

- Code Popularity: 11,478 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the P1089 INFINITI Code?

  • Faulty VVEL Control Shaft Position Sensor Bank 1
  • VVEL Control Shaft Position Sensor Bank 1 harness is open or shorted
  • VVEL Control Shaft Position Sensor Bank 1 circuit poor electrical connection
  • Faulty VVEL control module

|How to Fix the P1089 INFINITI Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P1089 INFINITI code?

Labor: 1.0

The cost to diagnose the P1089 INFINITI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P1089 INFINITI code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P1089 INFINITI Code Mean?

VVEL (Variable Valve Event & Lift) is a system that controls valve event and valve lift continuously. Rotational movement of the drive shaft equipped with eccentric cam is transmitted to output cam via the rocker arm and two kinds of links to depress the intake valve. The Engine Control Module (ECM) decides the target valve lift according to the driving condition and sends the command signal to the VVEL control module. The VVEL control module controls the rotation of the control shaft using the VVEL actuator motor and changes the movement of the output cam by shifting the link supporting point. As a result, valve lift changes continuously to improve engine output and response.
VVEL control shaft position sensor (1) is placed on VVEL actuator sub assembly and detects the control shaft position angle. A magnet is pressed into the arm on the edge of control shaft.
The magnetic field changes as the magnet rotates together with the arm resulting in the output voltage change of the sensor. VVEL control module detects the actual position angle through the voltage change and sends the signal to ECM.

VVEL Control Shaft Position Sensor Bank 1 Circuit

|Need more information with the P1089 INFINITI code?

Need more information on how to fix the P1089 INFINITI code?
Get Access to Factory Service Manuals

|Need help with a P1089 INFINITI code?

Get the p1089 infiniti code diagnosed by a professional: Find a repair shop in your area