Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
This code just means that the Powertrain Control Module (PCM) didn't complete a full diagnosis cycle, and is set when the battery has been disconnected, codes have been cleared, or sometimes even when the vehicle has been towed. No scanner is necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnosis cycle will clear the code. Clearing the code will reset the light unless other codes are present.
The cost to diagnose the P1000 Land Rover code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The On-Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check. If Diagnostic Trouble Code (DTC) P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.
Need more information on how to fix the P1000 Land Rover code? Get Access to Factory Service Manuals
Get the P1000 Land Rover code diagnosed by a professional: Find a repair shop in your area