P1000 2010 FORD FUSION Code - On Board Diagnostic System Readiness Test Not Complete
|P1000 2010 FORD FUSION code possible causes
- The vehicle is new from the factory.
- Battery or Powertrain Control Module (PCM) had recently been disconnected.
- An OBD monitor failure occurred before completion of an OBD drive cycle.
- PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.
|How is the P1000 2010 FORD FUSION code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P1000 2010 FORD FUSION code tech notes
This code just means that the PCM didn't complete a full diagnose cycle, and is set when the battery have been disconnected, codes have been cleared or sometimes even when the vehicle have been towed. No scanner it's necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnose cycle will clear the code. Clearing the code will reset the light unless other codes present.
|What is the cost to diagnose the P1000 2010 FORD FUSION code
The cost to diagnose the P1000 2010 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P1000 2010 FORD FUSION code detected?
If DTC P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.
|What are P1000 2010 FORD FUSION code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is P1000 2010 FORD FUSION code meaning?
The On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.