P0BFD GMC - Drive Motor Phase U-V-W Not Plausible
P0BFD GMC Possible Causes
- Faulty Starter Generator Control Module
- Starter Generator Control Module harness is open or shorted
- Starter Generator Control Module circuit poor electrical connection
How is the P0BFD GMC code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0BFD GMC code
Labor: 1.0The cost to diagnose the P0BFD GMC code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
P0BFD GMC MeaningThe generator control module also called the starter generator control module is comprised of the following three control modules; the hybrid powertrain control module, 14 volt power module and the drive motor control module. These three control modules are non serviceable and are part of the generator control module.
The drive motor control module operates the starter generator, also referred to as the drive motor, based upon hybrid powertrain control module commands. The drive motor control module controls the speed and output torque of the starter generator through the sequencing actuation of high current switching transistors called insulated gate bipolar transistors. The starter generator operates utilizing 3-phase alternating current (AC) electricity. Each insulated gate bipolar transistors operates a single phase of the starter generator. Each phase is individually identified as U, V and W. The drive motor control module monitors the current of phase U and W. The drive motor control module uses logic to calculate phase V current values. This information is used in order to detect over current conditions.
Because all starter generator phase circuits are electrically joined together, they should each flow about the same amount of current. The drive motor control module performs a mathematical calculation to verify that the phase current sensors are accurate. If the current sensors indicate about the same amount of phase current, the sum of the calculation should be near zero. If the currents are not similar, this DTC will set.
More InformationNeed more information on how to fix the P0BFD GMC code?
Get Access to Factory Service Manuals