Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the P0AAD GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Battery Energy Control Module monitors an inlet air temperature sensor that is located at the inlet of the Hybrid/EV Battery Pack. This temperature sensor is a variable resistor that measures the air temperature of the incoming air which is used to heat and cool the Hybrid/EV Battery Sections and the internal electronics of the Starter/Generator Control Module. The Battery Energy Control Module supplies 5 V to the signal circuit and a ground for the low reference circuit. The inlet air temperature sensor resistance changes with temperature of the incoming inlet air. As the temperature decreases, the sensor resistance increases. As the temperature increases, the sensor resistance decreases. The Starter/Generator Control Module will control the Hybrid/EV Battery Pack Cooling Fan based on the inlet air temperature and hybrid/EV battery temperature sensors.
The Starter/Generator Control Module performs a rationality diagnostic that compares the air Inlet temperature sensor output signal to the average battery temperature of the six battery cell temperature sensors. This diagnostic gets one chance to run during a drive cycle after a specific vehicle off time.
Need more information on how to fix the P0AAD GMC code? Get Access to Factory Service Manuals
Get the P0AAD GMC code diagnosed by a professional: Find a repair shop in your area