Engine-Codes - Cadillac - P0AA6 CADILLAC

P0AA6 CADILLAC Code - Hybrid/EV Battery Voltage System Isolation Lost

- Code Popularity: 950 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the P0AA6 CADILLAC Code?

  • Faulty Hybrid/EV Battery Pack
  • Hybrid/EV Battery Pack harness is open or shorted
  • Hybrid/EV Battery Pack circuit poor electrical connection

|How to Fix the P0AA6 CADILLAC Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P0AA6 CADILLAC code?

Labor: 1.0

The cost to diagnose the P0AA6 CADILLAC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P0AA6 CADILLAC code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0AA6 CADILLAC Code Mean?

The Battery Energy Control Module will diagnose its own systems and determine when a fault condition is present. Diagnostics and system status is communicated from the battery energy control module to the vehicle control interface module through serial data. The vehicle control interface module is the host controller for Diagnostic Trouble Code (DTC) information.
The vehicle is equipped with a high voltage isolation monitor feature. The purpose of the high voltage isolation circuit is to test the resistance between the high voltage positive and negative direct current (DC) bus and chassis ground. The battery energy control module only runs this test when the ignition transitions from ON to OFF and the high voltage contactor relays have opened. The battery energy control module has an internal isolation sensor that measures the resistance between the high voltage DC positive and negative bus and chassis ground. The battery energy control module runs an internal self check of this sensor circuit. The battery energy control module sends an AC signal over the DC bus and monitors its amplitude. A low amplitude or collapsed return signal indicates a loss of resistance to chassis ground and a loss of isolation will be indicated by the hybrid powertrain control module 2. Because this diagnostic runs after system power down, the diagnostic status does not get reported until the next key cycle.

Hybrid/EV Battery Voltage System Isolation Lost

|Need more information with the P0AA6 CADILLAC code?

Need more information on how to fix the P0AA6 CADILLAC code?
Get Access to Factory Service Manuals

|Need help with a P0AA6 CADILLAC code?

Get the P0aa6 Cadillac code diagnosed by a professional: Find a repair shop in your area