Engine-Codes - Generic - P0A9E

P0A9E Code - Hybrid/EV Battery Temperature Sensor 1 Circuit High Voltage

- Code Popularity: 9,471 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P0A9E?

  • Faulty Hybrid/EV Battery Assembly
  • Hybrid/EV Battery Assembly harness is open or shorted
  • Hybrid/EV Battery Assembly circuit poor electrical connection
  • Faulty Hybrid/EV Battery Interface Control Module

|How to Fix the P0A9E Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code P0A9E?

Labor: 1.0

The cost to diagnose the P0A9E code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your Car have Safety Recalls? → Check here

|What are Code P0A9E Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0A9E Code Mean?

Hybrid/EV Battery Temperature Sensors are used to monitor the battery temperature. The non-serviceable battery temperature sensors are located within the battery sections. Two temperature sensors are located in each battery section. The temperature sensor is a variable resistor that measures the temperature of the battery cell group. The hybrid/EV interface control module supplies 5 V to the signal circuit and is a ground for the low reference circuit. The battery temperature sensor resistance changes with battery temperature. As the temperature decreases, the sensor resistance increases. As the temperature increases, the sensor resistance decreases.
Each Hybrid/EV Battery Interface Control Module communicates the temperature sensor values to the Hybrid/EV Powertrain Control Module via serial data.
The Hybrid/EV Powertrain Control Module uses the battery temperature sensors to determine the Hybrid/EV Battery Module temperature in order to control the battery cooling system operation.
The Diagnostic Trouble Code (DTC) will be set when the hybrid battery temperature sensor is less than -69°C (-92°F).

P0A9E Code - Hybrid/EV Battery Temperature Sensor 1 Circuit High Voltage

|Need more Information on the P0A9E Code?

Need more information on how to fix the P0A9E code? Get Access to Factory Service Manuals

|Code P0A9E Information for Specific Makes

|Need Help with the P0A9E Code?

Get the P0A9E code diagnosed by a professional: Find a repair shop in your area