P0987 DODGE - 4C Hydraulic Pressure Test
P0987 DODGE Possible Causes
- Low or dirty fluid
- Faulty Line Pressure Sensor
- Line Pressure Sensor harness is open or shorted
- Line Pressure Sensor circuit poor electrical connection
How do I fix code P0987 DODGE?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P0987 DODGE code
Labor: 1.0The cost of diagnosing the P0987 DODGE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?While performing a transmission internal test the Transmission Control Module (TCM) detected that the Pressure Switch did not close 2 times
- Engine Light ON (or Service Engine Soon Warning Light)
P0987 DODGE MeaningThe Transmission Control Module (TCM) monitors the Transmission Fluid Pressure Sensor/Switch signal. The TCM sets the OBDII code when the Transmission Fluid Pressure Sensor/Switch is not to factory specifications.
P0987 DODGE More InformationNeed more information on how to fix the P0987 DODGE code?
Get Access to Factory Service Manuals