Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the P0966 Buick code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The pressure control solenoid 2 is part of the control solenoid valve assembly which has no serviceable parts. The normally high-pressure control solenoid 2 regulates and directs the pressure control solenoid 2 oil pressure to the 3-5 reverse clutch regulator valve and 3-5 reverse clutch boost valve. Increasing pressure control solenoid 2 pressure increases pressure to the 3-5 reverse clutch. The Transmission Control Module (TCM) varies the current to the pressure control solenoid 2 through a low side driver. Decreasing the current to the pressure control solenoid 2 increases pressure control solenoid 2 oil pressure by closing OFF the solenoid exhaust port. Increasing the current to the pressure control solenoid 2 decreases pressure control solenoid 2 oil pressure by opening the solenoid exhaust port. Pressure control solenoid 2 power is supplied by the Transmission Control Module through a high side driver. The high-side driver protects the circuit and components from excessive current flow. If excessive current flow is detected, the high side driver will turn OFF. When the fault is corrected, the high-side driver will reset.
The Diagnostic Trouble Code (DTC) will be set when the Transmission Control Module detects a short to ground on the clutch pressure control solenoid 2 control circuit for 1 s.
Need more information on how to fix the P0966 Buick code? Get Access to Factory Service Manuals
Get the P0966 Buick code diagnosed by a professional: Find a repair shop in your area