Engine-Codes - Generic - P0964

P0964 Code - Pressure Control Solenoid Valve 2 Control Circuit Open

- Code Popularity: 13,662 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the P0964 Code?

  • Low transmission fluid
  • Faulty Control Solenoid Valve Assembly
  • Control Solenoid Valve Assembly harness is open or shorted
  • Control Solenoid Valve Assembly circuit poor electrical connection

|How to Fix the P0964 Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P0964 code?

Labor: 1.0

The cost to diagnose the P0964 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P0964 code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0964 Code Mean?

The pressure control solenoid 2 is part of the control solenoid valve assembly which has no serviceable parts. The normally high-pressure control solenoid 2 regulates and directs the pressure control solenoid 2 oil pressure to the 3-5 reverse clutch regulator valve and 3-5 reverse clutch boost valve. Increasing pressure control solenoid 2 pressure increases pressure to the 3-5 reverse clutch. The Transmission Control Module (TCM) varies the current to the pressure control solenoid 2 through a low side driver. Decreasing the current to the pressure control solenoid 2 increases pressure control solenoid 2 oil pressure by closing OFF the solenoid exhaust port. Increasing the current to the pressure control solenoid 2 decreases pressure control solenoid 2 oil pressure by opening the solenoid exhaust port. Pressure control solenoid 2 power is supplied by the Transmission Control Module through a high side driver. The high-side driver protects the circuit and components from excessive current flow. If excessive current flow is detected, the high side driver will turn OFF. When the fault is corrected, the high-side driver will reset.
The Diagnostic Trouble Code (DTC) will be set when the Transmission Control Module detects an open on the pressure control solenoid valve 2 control circuit for 1 s.

Pressure Control Solenoid Valve 2 Control Circuit Open

|Need more information with the P0964 code?

Need more information on how to fix the P0964 code?
Get Access to Factory Service Manuals

|P0964 code information for specific makes

|Need help with a P0964 code?

Get the p0964 code diagnosed by a professional: Find a repair shop in your area