Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P0960 GMC code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The line pressure control solenoid is part of the control solenoid valve assembly which has no serviceable parts. The normally high line pressure control solenoid regulates and directs the pressure control solenoid oil pressure to the isolator/pressure regulator valve. Increasing pressure control solenoid line pressure increases transmission line pressure. The Transmission Control Module (TCM) varies the current to the line pressure control solenoid through a low side driver. Decreasing the current to the line pressure control solenoid increases line pressure control solenoid oil pressure by closing OFF the solenoid exhaust port. Increasing the current to the line pressure control solenoid decreases line pressure control oil pressure by opening the solenoid exhaust port. Line pressure control solenoid power is supplied by the Transmission Control Module through a high-side driver. The high-side driver protects the circuit and components from excessive current flow. If the excessive current flow is detected, the high side driver will turn OFF. When the fault is corrected the high-side driver will reset.
The Diagnostic Trouble Code (DTC) will be set when the Transmission Control Module detects an open circuit on the line pressure control solenoid valve control circuit for 1 s.
Need more information on how to fix the P0960 GMC code? Get Access to Factory Service Manuals
Get the P0960 GMC code diagnosed by a professional: Find a repair shop in your area