Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the P0889 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The transmission control relay is used to supply power to the solenoid pack when the transmission is in normal operating mode. When the relay is off, no power is supplied to the solenoid pack and the transmission is in Limp-in mode. The relay output is fed back to the Powertrain Control Module (PCM). It is referred to as the Transmission Control Relay Output circuit or switched battery.
Immediately after a controller reset (ignition key turned to the run position or after cranking engine), the PCM verifies that the relay contacts are open by checking for no voltage at the switched battery terminals. After this is verified, the voltage at the pressure switches is checked. There should be no voltage on the pressure switches at this time. The PCM will then activate the relay.
Need more information on how to fix the P0889 DODGE code?
Get Access to Factory Service Manuals
Get the p0889 dodge code diagnosed by a professional: Find a repair shop in your area