P0885 DODGE - TCM Power Relay Control Circuit/Open
P0885 DODGE Possible Causes
- Faulty Transmission Control Module (TCM) Power Relay
- Transmission Control Module (TCM) Power Relay harness is open or shorted
- Transmission Control Module (TCM) Power Relay circuit poor electrical connection
How is the P0885 DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0885 DODGE code
Labor: 1.0The cost to diagnose the P0885 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
P0885 DODGE MeaningThe transmission control relay is used to supply power to the solenoid pack when the transmission is in normal operating mode. When the relay is off, no power is supplied to the solenoid pack and the transmission is in Limp-in mode. The relay output is fed back to the Powertrain Control Module (PCM). It is referred to as the Transmission Control Relay Output circuit or switched battery.
Immediately after a controller reset (ignition key turned to the run position or after cranking engine), the PCM verifies that the relay contacts are open by checking for no voltage at the switched battery terminals. After this is verified, the voltage at the pressure switches is checked. There should be no voltage on the pressure switches at this time. The PCM will then activate the relay.
More InformationNeed more information on how to fix the P0885 DODGE code?
Get Access to Factory Service Manuals