Engine-Codes - Gmc - P0842 GMC

P0842 GMC Code - Transmission Fluid Pressure Switch 1 Circuit Low Voltage

- Code Popularity: 4,450 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the P0842 GMC Code?

  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty Transmission Control Solenoid Valve Assembly
  • Transmission Control Solenoid Valve Assembly harness is open or shorted
  • Transmission Control Solenoid Valve Assembly circuit poor electrical connection

|How to Fix the P0842 GMC Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the cost to diagnose the P0842 GMC code?

Labor: 1.0

The cost to diagnose the P0842 GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P0842 GMC code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0842 GMC Code Mean?

The Transmission Fluid Pressure (TFP) switch 1 is part of the control solenoid valve assembly, which has no serviceable parts. The Transmission Control Module (TCM) supplies a signal circuit to the TFP Switch 1. The TFP Switch 1 has an internal case ground. TFP Switch 1 is normally closed or LOW. When oil pressure is present at the TFP Switch 1, the switch is open or HIGH. The normally high clutch pressure control (PC) solenoid 2 controls pressure to the 3-5 reverse clutch regulator valve. The TCM monitors the TFP switch 1 to determine the position of the 3-5 reverse clutch regulator valve. When the 3-5 reverse clutch is commanded OFF, pressure is present on the TFP switch 1. When the 3-5 reverse clutch is commanded ON, the 3-5 reverse clutch regulator valve moves and pressure to the TFP switch 1 is exhausted through the 3-5 reverse clutch regulator valve. The Diagnostic Trouble Code (DTC) will be set when the TCM detects that the TFP switch 1 signal voltage remains LOW after the 3-5-R clutch transitions from a HIGH pressure state to a LOW pressure state. The TCM counts each incident. The DTC sets when 25 counts are accumulated.

Transmission Fluid Pressure Switch 1 Circuit Low Voltage

|Need more information with the P0842 GMC code?

Need more information on how to fix the P0842 GMC code?
Get Access to Factory Service Manuals

|Need help with a P0842 GMC code?

Get the P0842 Gmc code diagnosed by a professional: Find a repair shop in your area