P083B DODGE - LC Pressure Switch Rationality
P083B DODGE Possible Causes
- TIPM Transmission Control Output Circuit Open
- LC Pressure signal circuit open
- LC Pressure signal circuit shortedn ground
- LC Pressure signal circuit shorted to voltage
- Transmission solenoid
- Internal transmission problems
- Faulty Powertrain Control Module (PCM)
How is the P083B DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P083B DODGE code
Labor: 1.0The cost to diagnose the P083B DODGE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
P083B DODGE MeaningThe Transmission system uses three pressure switches to monitor the fluid pressure in the L/R, LC, and OD elements. The pressure switches are continuously monitored for the correct states in each gear. The LC pressure switch monitors the fluid pressure to the LC clutch to confirm proper operation of the LC solenoid. If the LC pressure switch is identified as closed in P or N, the code will immediately be set and normal operation will be allowed for that given key start. If the problem is identified for 3 successive ignition cycles, the transmission will go into Limp-in mode.
More InformationNeed more information on how to fix the P083B DODGE code?
Get Access to Factory Service Manuals