P083A DODGE - LC Hydraulic Pressure Test
P083A DODGE Possible Causes
- TIPM Transmission Control Output Circuit Open
- LC Pressure signal circuit open
- LC Pressure signal circuit shortedn ground
- LC Pressure signal circuit shorted to voltage
- Transmission solenoid
- Internal transmission problems
- Faulty Powertrain Control Module (PCM)
How is the P083A DODGE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P083A DODGE code
Labor: 1.0The cost to diagnose the P083A DODGE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
P083A DODGE MeaningPressure switches are normally open (off or no pressure applied) and read high (+12 volts). When an element is applied, the corresponding pressure switch closes to ground (0.0 volts) or turns on. The controller tests the LC pressure switch when it is open (when the corresponding friction element is not applied) by briefly applying the LC element which will cause the corresponding pressure switch to close. The test verifies that the switches are operational and that the switch will close when the corresponding element is applied. If a switch fails to respond to two consecutive tests, the transmission system defaults to limp-in mode and illuminates the MIL.
More InformationNeed more information on how to fix the P083A DODGE code?
Get Access to Factory Service Manuals