Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
There is a factory service bulletin for the following Jeep models:
2003-2005 Jeep Wrangler
2003-2005 Jeep Liberty
2003-2005 Jeep Cherokee
Jeep Factory Service Bulletin OBDII Code P0750
The cost to diagnose the P0750 Jeep code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Low Reverse (LR) is monitored at initially power-up, then every 10 seconds thereafter. The solenoids will also be tested immediately after a gear ratio or pressure switch error is detected. The P0750 code is detected when the Transmission Control Module (TCM) detects three consecutive solenoid continuity test failures, or one failure if the test is run in response to a gear ratio or pressure switch error
Need more information on how to fix the P0750 Jeep code? Get Access to Factory Service Manuals
Get the P0750 Jeep code diagnosed by a professional: Find a repair shop in your area