P0746 2009 TOYOTA CAMRY Code - Pressure Control Solenoid 'A' Performance
|P0746 2009 TOYOTA CAMRY code possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift Solenoid Valve SL Remains Closed Or Open
- Faulty line pressure solenoid valve
- Line pressure solenoid valve harness is open or shorted
- Line pressure solenoid valve circuit poor electrical connection
|How is the P0746 2009 TOYOTA CAMRY code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0746 2009 TOYOTA CAMRY code tech notes
When a transmission solenoid is malfunctioned, in most cases the problem is not the electrical part of the solenoid; the problem is foreign material obstructing the mechanical function of the solenoid or the flow of the fluid through the transmission valve body. If the transmission fluid is dirty, it's recommended to change the transmission fluid and if possible removing the transmission pan for further diagnosis. Excessive debris or metal particles on the transmission pan could be an indication that there is a mechanical transmission failure and that the transmission will need to be rebuilt or replaced.
|What is the cost to diagnose the P0746 2009 TOYOTA CAMRY code
The cost to diagnose the P0746 2009 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0746 2009 TOYOTA CAMRY code detected?
The gear required by the Engine Control Module (ECM) does not match the actual gear when driving
|What are P0746 2009 TOYOTA CAMRY code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission shift shock
|What is P0746 2009 TOYOTA CAMRY code meaning?
The Pressure Control (PC) Solenoid Valve an electronic pressure regulator that controls transmission line pressure based on current flow through its coil windings. As current flow is increased, the magnetic field produced by the coil moves the solenoid’s plunger further away from the exhaust port. Opening the exhaust port decreases the output fluid pressure regulated by the PC solenoid valve, which ultimately decreases line pressure. The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the Transmission Control Module (TCM).