Engine-Codes - Mazda - P0744 Mazda

P0744 Mazda Code - Slip Control Malfunction

- Code Popularity: 33,037 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0744 Mazda?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty torque converter clutch solenoid valve
  • Torque converter clutch solenoid valve harness is open or shorted
  • Torque converter clutch solenoid valve circuit poor electrical connection
  • Low transmission fluid level
  • Dirty transmission fluid
⚠ Does your Mazda have Safety Recalls? → Check here

How to Fix the DTC P0744 Mazda?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0744 Mazda Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0744 Mazda code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The P0744 is detected when A/T cannot perform lock-up even if electrical circuit is good.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0744 Mazda Code Mean?

The Torque Converter Clutch (TCC) solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

P0744 Mazda Code - Slip Control Malfunction

Need more Information on the Code?

Need more information on how to fix the P0744 Mazda code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0744 Mazda code diagnosed by a professional: Find a repair shop in your area