P0744 2011 NISSAN ROGUE - Torque Converter Clutch Circuit Intermittent
P0744 2011 NISSAN ROGUE Possible Causes
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness is open or shorted
- Torque converter clutch solenoid valve circuit poor electrical connection
- Low transmission fluid level
- Dirty transmission fluid
First diagnose P0744 2011 NISSAN ROGUE code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
P0744 2011 NISSAN ROGUE Tech NotesWhen the a transmission solenoid is working intermittent, in most cases the problem is not the electrical part of the solenoid; the problem is foreign material obstructing the mechanical function of the solenoid or the flow of the fluid through the transmission valve body. If the transmission fluid is very dirty, it is recommend changing the transmission fluid and if possible removing the transmission pan for further diagnosis. Excessive debris or metal particles on the transmission pan could be an indication that there is a transmission mechanical failure and that the transmission will need to be rebuilt or replaced.
Cost of diagnosing the P0744 2011 NISSAN ROGUE code
Labor: 1.0The cost of diagnosing the P0744 2011 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0744 2011 NISSAN ROGUE code detected?This malfunction is detected when the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunctions (circuits open or shorted), but also by mechanical malfunctions such as control valve sticking, improper solenoid valve operation, etc.
P0744 2011 NISSAN ROGUE Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0744 2011 NISSAN ROGUE MeaningThe Torque Converter Clutch (TCC) solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
P0744 2011 NISSAN ROGUE More InformationNeed more information on how to fix the P0744 2011 NISSAN ROGUE code?
Get Access to Factory Service Manuals