Engine-Codes - Honda - P0743 HONDA

P0743 HONDA Code - Torque Converter Clutch Circuit Electrical

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P0743 HONDA code possible causes

  • Dirty transmission fluid
  • Low transmission fluid level
  • Faulty Torque Converter Clutch (TCC) Solenoid Valve
  • Torque Converter Clutch Solenoid Valve harness is open or shorted
  • Torque Converter Clutch Solenoid Valve circuit poor electrical connection

|How is the P0743 HONDA code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0743 HONDA code tech notes

This is an electrical problem code. Could be a problem with the harness to the Torque Converter Clutch (TCC) solenoid, the TCC solenoid connector, or the TCC solenoid itself.

|What is the cost to diagnose the P0743 HONDA code

Labor: 1.0

The cost to diagnose the P0743 HONDA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P0743 HONDA code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What is P0743 HONDA code meaning?

The Torque Converter Clutch (TCC) is designed to increase efficiency by mechanically coupling the engine to the transmission. The TCC solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter. The lock-up operation, however, is prohibited when A/T fluid temperature is too low. When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up. By performing a voltage drop test, the ECM detects that the Torque Converter Clutch (TCC) solenoid circuit is open or shorted and sets the Diagnostic Trouble Code (DTC).

|Need more information with the P0743 HONDA code?

Need more information on how to fix the P0743 HONDA code?
Get Access to Factory Service Manuals

|Need help with a P0743 HONDA code?

Get the P0743 Honda code diagnosed by a professional: Find a repair shop in your area