Engine-Codes - Scion - P0741 Scion

P0741 Scion Code - Torque Converter Clutch Solenoid Performance

- Code Popularity: 19,359 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P0741 Scion?

  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty Torque Converter Clutch Solenoid Valve (Shift Solenoid Valve SL)
  • Torque Converter Clutch Solenoid Valve harness or connectors
  • Torque Converter Clutch Solenoid Valve circuit is open or shorted
  • Transmission valve body assembly is blocked
  • Torque converter assembly
  • Transmission internal mechanical problem

|How to Fix the P0741 Scion Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code P0741 Scion?

Labor: 1.0

The cost to diagnose the P0741 Scion code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code P0741 Scion Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0741 Scion Code Mean?

Torque converter lock-up is controlled by the Engine Control Module (ECM) based on speed sensor NT, speed sensor NC, engine speed, engine load, engine temperature, vehicle speed, ATF temperature, and gear selection. The ECM determines the lock-up status of the torque converter by comparing the engine speed (NE) to the input turbine speed (NT). The ECM calculates the actual transmission gear by comparing the input turbine speed (NT) to the counter gear speed (NC). When conditions are appropriate, the ECM requests lock-up by applying a control voltage to shift solenoid valve SL. When the shift solenoid valve SL is turned on, it applies pressure to the lock-up relay valve and locks the torque converter.
If the ECM detects no lock-up after lock-up has been requested or if it detects lock-up when it is not requested, the ECM interprets this as a fault in shift solenoid valve SL or lock-up system performance. The ECM will turn on the MIL and store the Diagnostic Trouble Code (DTC).
Torque Converter Clutch Solenoid Performance

|Need more Information on the P0741 Scion Code?

Need more information on how to fix the P0741 Scion code? Get Access to Factory Service Manuals

|Need Help with the P0741 Scion Code?

Get the P0741 Scion code diagnosed by a professional: Find a repair shop in your area