P0741 MITSUBISHI - Torque Converter Clutch System Malfunction
P0741 MITSUBISHI Possible Causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem
First diagnose P0741 MITSUBISHI code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the P0741 MITSUBISHI code
Labor: 1.0The cost of diagnosing the P0741 MITSUBISHI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0741 MITSUBISHI code detected?Lock-up does not occur when driving in lock-up range or lockup remains ON in lock-up OFF range
P0741 MITSUBISHI Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0741 MITSUBISHI MeaningThe torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
P0741 MITSUBISHI More InformationNeed more information on how to fix the P0741 MITSUBISHI code?
Get Access to Factory Service Manuals