Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
There is a factory service bulletin for the following Ford models:
1996-2003 Ford Taurus
1996-2003 Ford Windstar
1996-2003 Ford Taurus, Windstar Factory Service Bulletin OBDII Code P0741
The cost to diagnose the P0741 Ford code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Engine Control Module (ECM) detected excessive transmission slippage or no TCC solenoid operation
The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
Need more information on how to fix the P0741 Ford code? Get Access to Factory Service Manuals
Get the P0741 Ford code diagnosed by a professional: Find a repair shop in your area