Engine-Codes - Dodge - P0740 Dodge

P0740 Dodge Code - Torque Converter Clutch Circuit

- Code Popularity: 150,783 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P0740 Dodge?

  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty torque converter clutch solenoid valve
  • Torque converter clutch solenoid valve harness is open or shorted
  • Torque converter clutch solenoid valve circuit poor electrical connection

|How to Fix the P0740 Dodge Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Code P0740 Dodge Tech Notes





User Submitted Video

|What is the Cost to Diagnose the Code P0740 Dodge?

Labor: 1.0

The cost to diagnose the P0740 Dodge code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|When is the P0740 Dodge Code Detected?

Torque Converter Clutch (TCC) unlocked for 10 sec., ECM commands converter lock-up and did not record engine speed drop.

|What are Code P0740 Dodge Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Transmission shift shock
  • Vehicle may not shift into the highest gear

|What Does the P0740 Dodge Code Mean?

The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

Torque Converter Clutch Circuit

|Need more Information on the P0740 Dodge Code?

Need more information on how to fix the P0740 Dodge code? Get Access to Factory Service Manuals

|Need Help with the P0740 Dodge Code?

Get the P0740 Dodge code diagnosed by a professional: Find a repair shop in your area