Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
There is a Factory Service Bulletin for the Jeep following models:
2005-2006 Jeep Liberty
2005-2006 Jeep Cherokee
2005-2006 Jeep Grand Cherokee
2006 Jeep Commander
Jeep Factory Service Bulletin OBDII Code P0736
The cost to diagnose the P0736 Jeep code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
Need more information on how to fix the P0736 Jeep code? Get Access to Factory Service Manuals
Get the P0736 Jeep code diagnosed by a professional: Find a repair shop in your area