Engine-Codes - Jeep - P0733 Jeep

P0733 Jeep Code - Gear Ratio Error In Third Gear

- Code Popularity: 33,069 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0733 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Shift solenoids
  • Transmission mechanical problems
  • Transmission hydraulic control circuit

Code Tech Notes

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.





User Submitted Video

⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC P0733 Jeep?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0733 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0733 Jeep code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

What Does the P0733 Jeep Code Mean?

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (3rd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

P0733 Jeep Code - Gear Ratio Error In Third Gear

Need more Information on the Code?

Need more information on how to fix the P0733 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0733 Jeep code diagnosed by a professional: Find a repair shop in your area