P0730 NISSAN Code - Belt Damage
|P0730 NISSAN code possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit
|How is the P0730 NISSAN code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0730 NISSAN code tech notesThe P0730 code, is for Nissan vehicles with CVT transmission. Start by inspecting the transmission fluid level and condition, and change fluid if necessary. If the problem persists, you should contact your Nissan dealer for more information.
|What is the cost to diagnose the P0730 NISSAN code
Labor: 1.0The cost to diagnose the P0730 NISSAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0730 NISSAN code detected?The TCM has detected that the transmission is trying to mechanically shift to a lower gear than intended
|What are P0730 NISSAN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting
|What is P0730 NISSAN code meaning?Transmission Control Module (TCM) selects the gear ratio using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal. Then it changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley.
|Need more information with the P0730 NISSAN code?Need more information on how to fix the P0730 NISSAN code?
Get Access to Factory Service Manuals