Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.
The cost to diagnose the P0730 Audi code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The TCM has detected that the transmission is trying to mechanically shift to a lower gear than intended
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from speed sensor (revolution sensor)
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.
Need more information on how to fix the P0730 Audi code? Get Access to Factory Service Manuals
Get the P0730 Audi code diagnosed by a professional: Find a repair shop in your area